| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: xilinx-trng - Remove crypto_rng interface
Implementing the crypto_rng interface has no purpose, as it isn't used
in practice. It's being removed from other drivers too. Just remove
it. This leaves hwrng, which is actually used.
Tagging with 'Cc stable' due to the bugs that this removes:
- xtrng_trng_generate() sometimes returned success even when it didn't
fill in all the bytes.
- It was possible for xtrng_trng_generate() and
xtrng_hwrng_trng_read() to run concurrently and interfere with each
other, as the locking code in xtrng_hwrng_trng_read() was broken. |
| An issue was discovered in Lantronix EDS3000PS 3.1.0.0R2. The host parameter of the TFTP client in the Filesystem Browser page is not properly sanitized. This can be exploited to escape from the original command and execute an arbitrary one with root privileges. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: hid-goodix-spi: validate report size to prevent stack buffer overflow
goodix_hid_set_raw_report() builds a protocol frame in a 128-byte stack
buffer (tmp_buf), writing an 11-12 byte header followed by the
caller-supplied report data. The HID core caps report size at
HID_MAX_BUFFER_SIZE (16384) by default, while the driver does not set
hid_ll_driver.max_buffer_size and performs no bounds checking before
copying the payload:
memcpy(tmp_buf + tx_len, buf, len);
A hidraw SET_REPORT ioctl with a report larger than ~116 bytes
overflows the stack buffer.
Add a size check after constructing the header, rejecting reports that
would exceed the buffer capacity.
Discovered by Atuin - Automated Vulnerability Discovery Engine. |
| The administrator password can be changed without knowledge of the current password. When chained with an authentication bypass vulnerability, this issue may allow unauthenticated attackers to modify the administrator password. |
| An issue was discovered in Lantronix EDS5000 2.1.0.0R3. An authenticated attacker can inject OS commands into the "tunnel" parameter when killing a tunnel connection. Injected commands are executed with root privileges. |
| An issue was discovered in Lantronix EDS5000 2.1.0.0R3. An authenticated attacker can inject OS commands into the "name" parameter when deleting SSL credentials through the management interface. Injected commands are executed with root privileges. |
| An issue was discovered in Lantronix EDS5000 2.1.0.0R3. The Log Info page allows users to see log files by specifying their names. Due to a missing sanitization in the file name parameter, an authenticated attacker can inject arbitrary OS commands that are executed with root privileges. |
| XING CPTrans-ME-X contains an OS Command Injection (CWE-78). Unauthenticated OS command may be injected. |
| Memory Allocation with Excessive Size Value (CWE-789) in the ES|QL query processing of Elasticsearch can lead to denial of service via Excessive Allocation (CAPEC-130). An authenticated user able to submit ES|QL queries could send a specially crafted query whose evaluation allocates an unbounded amount of heap memory, exhausting the available heap on the receiving node and causing the node to become unavailable. |
| NVIDIA NeMo for Linux contains a vulnerability where an attacker may cause OS command injection. A successful exploit of this vulnerability may lead to code execution, data tampering, escalation of privileges and information disclosure. |
| An issue was discovered in Lantronix EDS5000 2.1.0.0R3. The SSH Client and SSH Server pages are affected by multiple OS injection vulnerabilities due to missing sanitization of input parameters. An attacker can inject arbitrary commands in delete actions of various objects, such as server keys, users, and known hosts. Commands are executed with root privileges. |
| A command injection vulnerability exists in MLflow's model serving container initialization code, specifically in the `_install_model_dependencies_to_env()` function. When deploying a model with `env_manager=LOCAL`, MLflow reads dependency specifications from the model artifact's `python_env.yaml` file and directly interpolates them into a shell command without sanitization. This allows an attacker to supply a malicious model artifact and achieve arbitrary command execution on systems that deploy the model. The vulnerability affects versions 3.8.0 and is fixed in version 3.8.2. |
| In the Linux kernel, the following vulnerability has been resolved:
arm64: dts: renesas: ironhide: Describe inline ECC carveouts
The DBSC5 DRAM controller protects DRAM content using inline ECC.
The inline ECC utilizes areas of DRAM for its operation, which are
in the DRAM address range, but must not be accessed or modified.
Describe the inline ECC carveout areas used by the DBSC5 controller
on this hardware as reserved-memory, which must not be accessed.
Include DRAM areas which are unprotected by ECC as well, those are
parts of the DRAM which directly precede the ECC carveout.
In case of high DRAM utilization, unless the inline ECC carveouts
are properly reserved, Linux may use and corrupt the memory used
by the DBSC5 DRAM controller for inline ECC, which would lead to
the system becoming unstable. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: seg6: clear IPv4 control block on IPIP decapsulation
End.DX4 and End.DT4 decapsulate an IPv4 packet through
decap_and_validate() and send it directly to IPv4 routing. The inner
packet therefore bypasses ip_rcv_core(), which normally clears IPCB
before IPv4 interprets skb->cb.
The skb instead retains IP6CB data from the outer packet. IP6CB and
IPCB use the same skb->cb storage, so IP6CB(skb)->lastopt overlaps
IPCB(skb)->opt.optlen and srr, while IP6CB(skb)->nhoff overlaps rr and
ts.
The sender can make the stale optlen byte nonzero with a valid outer
extension-header chain. The reproducers put an eight-byte Destination
Options header immediately after the 40-byte IPv6 header and before the
Segment Routing Header. ipv6_destopt_rcv() records the sender-controlled
Destination Options offset in both lastopt and nhoff, setting them to
40. On the reproduced little-endian x86-64 kernel, IPv4 therefore sees
optlen = 40 and rr = 40.
Both tcp_v4_save_options() and __ip_options_echo() skip option copying
when optlen is zero. Here optlen is 40, so the TCP SYN path allocates
room for 40 bytes of option data and calls __ip_options_echo(). The
stale rr value makes that function read inner packet byte 41 as the
Record Route option length. The reproducers set that sender-controlled
byte to 255, so __ip_options_echo() copies 255 bytes into the 40-byte
option-data area.
Separate End.DX4 and End.DT4 reproducers on the unpatched v7.2-rc5
kernel both produced:
BUG: KASAN: slab-out-of-bounds in __ip_options_echo()
Write of size 255
The relevant End.DX4 call path is:
__ip_options_echo
tcp_v4_route_req
tcp_conn_request
tcp_v4_conn_request
tcp_rcv_state_process
tcp_v4_do_rcv
tcp_v4_rcv
ip_protocol_deliver_rcu
ip_local_deliver_finish
ip_local_deliver
input_action_end_dx4_finish
input_action_end_dx4
The relevant End.DT4 call path is:
__ip_options_echo
tcp_v4_route_req
tcp_conn_request
tcp_v4_conn_request
tcp_rcv_state_process
tcp_v4_do_rcv
tcp_v4_rcv
ip_protocol_deliver_rcu
ip_local_deliver_finish
ip_local_deliver
input_action_end_dt4
tcp_v4_save_options() is inlined into the tcp_v4_route_req() path, so
it does not appear as a separate frame.
When decap_and_validate() handles IPPROTO_IPIP, save the ingress
interface from IP6CB, clear IPCB, and restore the saved value. Doing
this in the common decapsulation path covers End.DX4, End.DT4, and
End.DT46's IPv4 arm.
Use IP6CB(skb)->iif rather than skb->skb_iif. These actions run after
l3mdev processing, which can replace skb_iif with the L3 master;
IP6CB iif still records the receiving interface set at IPv6 ingress. |
| MOOS ui-moos through 50b9c6c contains a buffer overflow vulnerability in ScopeTabPane.cpp and ScopeGrid.cpp where client and variable names are formatted into fixed 1024-byte buffers using sprintf without length validation. Attackers can supply arbitrarily long MOOS identifiers that overflow the buffers when an operator selects process list entries or pokes variables, enabling code execution. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote authenticated attacker to execute arbitrary commands due to improper neutralization of special elements used in an OS command. |
| tokenizers (Hugging Face) is affected by an out-of-bounds buffer access in BpeBuilder::build (tokenizers/src/models/bpe/model.rs). When loading a tokenizer.json via Tokenizer::from_file/from_str, the builder sizes a scratch buffer to the longest vocabulary key, then writes each concatenated merge rule into it. A merge whose concatenated token exceeds the longest vocabulary key overruns the buffer, which Rust turns into a panic that aborts the process in Rust and FFI embeddings. This occurs at load time with no encoding required, so an attacker who supplies a crafted tokenizer.json can cause a denial of service. A secondary defect at the same location can cause a usize underflow (panic in debug, potential memory corruption in release) when continuing_subword_prefix is set and a merge token is shorter than the prefix. Observed in version 0.23.1. |
| An OS command injection issue in the log4j-cve-2021-44228-hotpatch package in Amazon Linux before 1.3-9 might allow a local user to execute arbitrary commands with root privileges via a Java process whose executable path contains embedded newline characters. |
| A vulnerability was determined in D-Link DNS-320 ShareCenter 2.06B01. This affects an unknown part of the file /cgi/file_sharing.cgi of the component File Sharing. Executing a manipulation of the argument fileurl can lead to os command injection. The attack can be launched remotely. The exploit has been publicly disclosed and may be utilized. |
| SEPPmail Secure Email Gateway before 15.0.6 deserializes attacker-controlled data in a privileged REST import workflow without adequate validation. An attacker with a privileged API token can execute arbitrary commands with "nobody" privileges. |
