| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Sandbox escape due to incorrect boundary conditions in the Widget: Win32 component. This vulnerability was fixed in Firefox 158, Firefox ESR 153.5, Thunderbird 158, and Thunderbird 153.5. |
| In the Linux kernel, the following vulnerability has been resolved:
net: stmmac: fix rx Scatter-Gather support
When a received frame is larger than dma_buf_sz, the DMA scatters it
across multiple RX descriptors (rx Scatter-Gather). The secondary RX
buffer (sec_page) was only allocated and programmed when split-header
(SPH) was active, so for regular frames buffer2 was neither allocated
nor backed by a valid mapping. As soon as an incoming frame overflowed
buffer1, the DMA wrote the overflow into the unmapped secondary-buffer
address, triggering an SMMU translation fault on IOMMU-based platforms:
arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402, iova=0x00000000, fsynr=0x7f0011, cbfrsynra=0x1c90, cb=11
arm-smmu 15000000.iommu: FSR = 00000402 [Format=2 TF], SID=0x1c90
arm-smmu 15000000.iommu: FSYNR0 = 007f0011 [S1CBNDX=127 WNR PLVL=1]
Enable scatter-gather for non-SPH frames on cores that can program an
independent secondary RX buffer (GMAC4/XGMAC): allocate and mark buffer2
as valid in stmmac_init_rx_buffers() and stmmac_rx_refill(), and account
for it in the buffer length computation. Legacy cores have no set_sec_addr
op, so they keep buffer2 disabled.
Since buffer2 is handed to the DMA at page offset 0, the page pool sync
window is widened to cover both buffers in every mode: offset is set to 0
and max_len to dma_buf_sz + stmmac_rx_offset().
The FCS can straddle the buffer1/buffer2 boundary and a descriptor
boundary, so it is now stripped from the tail of the assembled frame with
pskb_trim() instead of from a single buffer, avoiding an unsigned underflow
for frames that overflow a buffer by 1..3 bytes. For single-buffer frames
the XDP program must not see the FCS, so it is removed from the XDP buffer
before the program runs.
Native XDP currently only supports single-buffer (linear) frames. An
oversized frame accepted by the MAC (jumbo enabled) is received via
buffer2; the XDP program only sees buffer1, so on a TX/REDIRECT verdict
the frame is forwarded truncated. XDP multi-buffer support to handle
this case is planned as a follow-up.
AF_XDP zero-copy RX is not covered by this change: a ZC queue still
programs buffer2 at DMA address 0 (and XGMAC has no buffer2-valid bit),
so an oversized frame overflowing buffer1 can still trigger the same
SMMU translation fault. Handling is planned as a follow-up. |
| A flaw has been found in ztxz16 fastllm up to 1.8.2. Affected by this issue is the function SafeTensorItem::CreateBuffer of the file src/model.cpp of the component Safetensors Weight Loading. This manipulation of the argument data_offsets causes buffer overflow. The attack can be initiated remotely. The exploit has been published and may be used. The project was informed of the problem early through an issue report but has not responded yet. |
| A security vulnerability in HPE NonStop DNS 9.2.3 Non Secure Version could cause a Denial of Service. |
| BottleCRM 0.30 through 1.14.5 contains an HTML injection vulnerability in render_invoice_template() that allows authenticated organization members to inject markup into custom-template invoice PDFs. Attackers can place HTML and CSS in notes, terms, client name or address fields to overlay totals, payee and payment instructions in PDFs served via download, public links and emails. |
| holaOS through 2026.822.1 contains a missing authorization vulnerability in channel-gateway connectors that allows any messaging-platform user to submit agent tasks because the #isAllowed check accepts all senders when the default allowFrom list is empty. Attackers who can message the operator's Telegram, Slack, Discord, or other bot can have ChannelIngress.handle pass turns to the workspace agent, running configured tools on the operator's machine. |
| : Improper Restriction of Operations within the Bounds of a Memory Buffer vulnerability in Unitronics Unitronics UniStream Pro/UniLogic.
This issue affects Unitronics UniStream Pro/UniLogic: Unitronics UniStream Pro versions only (B10 / C10) – UniLogic versions prior to 1.41.329. |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: sr9700: include receive overhead in the length check
The receive fixup subtracts the Ethernet CRC from the reported packet
length, but compares that payload length against the whole remaining
receive buffer. The following copy starts after the three-byte header,
and the cursor advance consumes both that header and the four-byte CRC.
Require the payload to fit after SR_RX_OVERHEAD before copying it or
advancing to the next packet. The loop already ensures that the
remaining buffer is larger than the overhead, so the subtraction is
safe.
The issue was found by our static-analysis tool. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: fix wild memcpy access when formatting ondisk rtrefcount btree roots
LOLLM noticed that the inode btree root formatting methods copy too many
bytes -- there's only one set of keys in node blocks, not two. This
causes memory corruption of whatever's beyond the buffers. |
| A vulnerability was identified in Tencent ncnn up to 44b02dabdcf97499281a4692ebd65bad73dcf8b6. Affected by this vulnerability is the function matmul_transb of the file src/layer/matmul.cpp of the component MatMul. The manipulation leads to out-of-bounds read. The attack can be initiated remotely. The exploit is publicly available and might be used. The project was informed of the problem early through an issue report but has not responded yet. |
| An output escaping vulnerability in the Audit Logs component of Crafty Controller allows a remote, unauthenticated attacker to perform stored cross-site scripting via HTTP header injection |
| OPNsense is a FreeBSD based firewall and routing platform. Prior to version 26.1.11, the unauthenticated WebGUI login usernamefld accepts carriage-return and line-feed characters that survive LOG_AUTH processing through syslog-ng-lockout.conf into the syslog-ng program destination feeding lockout_handler. The consumer's readline() processing treats an injected fragment as a separate authentication event and selects the first syntactically valid IP address from the forged line. An attacker with network access to the login page can forge failure events for another IP, causing that IP to be added to the sshlockout PF table and its active states to be killed, or forge accepted events that reset an attacker's own brute-force counter. This can block administrative, DNS, gateway, or monitoring addresses and can bypass password-guessing lockout without authentication. This issue is fixed in version 26.1.11. |
| Incorrect boundary conditions in the JavaScript Engine component. This vulnerability was fixed in Firefox 158, Firefox ESR 115.43, Firefox ESR 153.5, Thunderbird 158, and Thunderbird 153.5. |
| Incorrect boundary conditions in the JavaScript Engine component. This vulnerability was fixed in Firefox 158, Firefox ESR 115.43, Firefox ESR 153.5, Thunderbird 158, and Thunderbird 153.5. |
| Buffer Overflow vulnerability in zserge jsmn jsmn HEAD 25647e6 allows a remote attacker to cause a denial of service via the jsmn.h, jsmn_parse(), example/jsondump.c, dump() components |
| Incorrect boundary conditions in the Layout component. This vulnerability was fixed in Firefox 158 and Thunderbird 158. |
| Improper neutralization of special elements in the NetBird client SSH configuration manager (client/ssh/config/manager.go) in NetBird versions 0.60.0 through 0.74.6 allows a malicious or compromised peer to execute arbitrary commands on other NetBird client hosts. The client writes a system-wide OpenSSH drop-in file (/etc/ssh/ssh_config.d/99-netbird.conf, or the equivalent under %PROGRAMDATA%\ssh\ssh_config.d on Windows) that embeds each peer FQDN or hostname inside a double-quoted Match host directive without escaping. A peer name containing a double quote breaks out of the quoted context and injects arbitrary SSH configuration directives, including exec commands, which run locally as any user on the host the next time that user runs ssh. Desktop clients on Linux, macOS, Windows and FreeBSD are affected; the Android and iOS apps are not. The issue is fixed in version 0.74.7, which accepts a peer FQDN or hostname only if it is a valid DNS name. |
| cpp-httplib is a C++ header-only HTTP/HTTPS library. From 0.29.0 until 0.51.0, Client::open_stream in httplib.h accepts a caller-controlled path that reaches detail::write_request_line() without the detail::encode_path() protection used by the ordinary buffered request path. Raw carriage-return and line-feed bytes in the path can therefore split the outbound HTTP/1.1 request line and inject attacker-shaped request metadata. Exploitation requires an embedding application to pass remote user input into the open_stream path and a backend or intermediary that interprets the injected bytes; the established impact is modification of backend-visible request data, not direct confidentiality or availability impact. This issue is fixed in version 0.51.0. |
| MCP Context Forge is an MCP gateway and administrative platform. Prior to 1.0.2, mcpgateway/config.py and .env.example ship a known JWT_SECRET_KEY, while verify_jwt_token() accepts HS256 tokens signed with that key and get_current_user() creates a platform administrator when the token subject matches PLATFORM_ADMIN_EMAIL and REQUIRE_USER_IN_DB is false. A remote unauthenticated attacker can therefore mint accepted administrator tokens without a database account. While the vulnerable signing key remains configured and the platform-admin bootstrap remains enabled, forged access survives password rotation, account deletion, and session revocation, allowing administrative disclosure, modification, and service disruption. This issue is fixed in version 1.0.2. |
| In the Linux kernel, the following vulnerability has been resolved:
nfsd: gate nfs3 setacl by argp->mask
nfsd3_proc_setacl() calls set_posix_acl() unconditionally for both
ACL_TYPE_ACCESS and ACL_TYPE_DEFAULT, passing argp->acl_access and
argp->acl_default verbatim. The NFSv3 ACL decoder only populates
those pointers when the corresponding mask bit is set:
nfs3svc_decode_setaclargs()
if (args->mask & NFS_ACL) decode into acl_access
if (args->mask & NFS_DFACL) decode into acl_default
/* otherwise the pointer stays NULL (pc_argzero) */
nfsd3_proc_setacl()
set_posix_acl(.., ACL_TYPE_ACCESS, argp->acl_access)
set_posix_acl(.., ACL_TYPE_DEFAULT, argp->acl_default)
set_posix_acl(idmap, dentry, type, NULL) is the VFS "remove this
ACL type" operation. A NULL pointer that means "the client did not
send this arm" is therefore indistinguishable from "the client
asked to remove this ACL". A SETACL with mask=NFS_ACL silently
drops the directory's default ACL; mask=0 drops both.
The sibling nfsd3_proc_getacl() already consults argp->mask before
touching each arm; mirror that in setacl.
Fix by wrapping each set_posix_acl() call in the matching mask bit
check and initializing error to 0 before inode_lock so that a
request with neither bit set leaves the on-disk ACLs untouched and
returns nfs_ok. The out_drop_lock path and the unconditional
posix_acl_release() at out: are preserved; both NULL-tolerate the
skipped arms. |
