| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: handle overlapped pclusters out of crafted images properly
syzbot reported a task hang issue due to a deadlock case where it is
waiting for the folio lock of a cached folio that will be used for
cache I/Os.
After looking into the crafted fuzzed image, I found it's formed with
several overlapped big pclusters as below:
Ext: logical offset | length : physical offset | length
0: 0.. 16384 | 16384 : 151552.. 167936 | 16384
1: 16384.. 32768 | 16384 : 155648.. 172032 | 16384
2: 32768.. 49152 | 16384 : 537223168.. 537239552 | 16384
...
Here, extent 0/1 are physically overlapped although it's entirely
_impossible_ for normal filesystem images generated by mkfs.
First, managed folios containing compressed data will be marked as
up-to-date and then unlocked immediately (unlike in-place folios) when
compressed I/Os are complete. If physical blocks are not submitted in
the incremental order, there should be separate BIOs to avoid dependency
issues. However, the current code mis-arranges z_erofs_fill_bio_vec()
and BIO submission which causes unexpected BIO waits.
Second, managed folios will be connected to their own pclusters for
efficient inter-queries. However, this is somewhat hard to implement
easily if overlapped big pclusters exist. Again, these only appear in
fuzzed images so let's simply fall back to temporary short-lived pages
for correctness.
Additionally, it justifies that referenced managed folios cannot be
truncated for now and reverts part of commit 2080ca1ed3e4 ("erofs: tidy
up `struct z_erofs_bvec`") for simplicity although it shouldn't be any
difference. |
| In the Linux kernel, the following vulnerability has been resolved:
media: go7007: fix a memleak in go7007_load_encoder
In go7007_load_encoder, bounce(i.e. go->boot_fw), is allocated without
a deallocation thereafter. After the following call chain:
saa7134_go7007_init
|-> go7007_boot_encoder
|-> go7007_load_encoder
|-> kfree(go)
go is freed and thus bounce is leaked. |
| libexpat through 2.5.0 allows a denial of service (resource consumption) because many full reparsings are required in the case of a large token for which multiple buffer fills are needed. |
| NCurse v6.4-20230418 was discovered to contain a segmentation fault via the component _nc_wrap_entry(). |
| Envoy is a cloud-native high-performance edge/middle/service proxy. Envoy’s HTTP/2 codec may leak a header map and bookkeeping structures upon receiving `RST_STREAM` immediately followed by the `GOAWAY` frames from an upstream server. In nghttp2, cleanup of pending requests due to receipt of the `GOAWAY` frame skips de-allocation of the bookkeeping structure and pending compressed header. The error return [code path] is taken if connection is already marked for not sending more requests due to `GOAWAY` frame. The clean-up code is right after the return statement, causing memory leak. Denial of service through memory exhaustion. This vulnerability was patched in versions(s) 1.26.3, 1.25.8, 1.24.9, 1.23.11. |
| D-Bus before 1.15.6 sometimes allows unprivileged users to crash dbus-daemon. If a privileged user with control over the dbus-daemon is using the org.freedesktop.DBus.Monitoring interface to monitor message bus traffic, then an unprivileged user with the ability to connect to the same dbus-daemon can cause a dbus-daemon crash under some circumstances via an unreplyable message. When done on the well-known system bus, this is a denial-of-service vulnerability. The fixed versions are 1.12.28, 1.14.8, and 1.15.6. |
| A flaw was found in GLib. GVariant deserialization is vulnerable to an exponential blowup issue where a crafted GVariant can cause excessive processing, leading to denial of service. |
| A flaw was found in glib, where the gvariant deserialization code is vulnerable to a denial of service introduced by additional input validation added to resolve CVE-2023-29499. The offset table validation may be very slow. This bug does not affect any released version of glib but does affect glib distributors who followed the guidance of glib developers to backport the initial fix for CVE-2023-29499. |
| A flaw was found in GLib. GVariant deserialization is vulnerable to a slowdown issue where a crafted GVariant can cause excessive processing, leading to denial of service. |
| Payload is a free and open source headless content management system. In versions from 3.0.0 before 3.90.0 and canary versions before 4.0.0-canary.34, a malformed multipart request body can cause multipart Content-Type processing to take an extremely long time, resulting in uncontrolled resource consumption. This issue is fixed in versions 3.90.0 and 4.0.0-canary.34. |
| IBM DataPower Gateway 11.0.0.0 through 11.0.0.2 could allow a remote attacker to cause a denial of service due to uncontrolled resource consumption. |
| IBM DataPower Gateway 10.5.0.0 through 10.5.0.22, 10.6.1 through 10.6.6, 10.6.0.0 through 10.6.0.10, and 11.0.0.0 through 11.0.0.2 could allow a remote attacker to cause a denial of service due to improper memoization of GraphQL fragment spreads. |
| MOOS-IvP versions through 24.8.1 contain a quadratic processing vulnerability in uFldNodeComms where each new node identity creates a ledger entry and triggers all-pairs distribution work. Attackers can supply unbounded distinct node names in reports to drive the shoreside broker into quadratic processing, delaying or preventing distribution of legitimate node reports. |
| MOOS core-moos through 10.4.0 contains a denial of service vulnerability in MOOSCommServer::ListenLoop() where the accept thread performs a blocking receive without timeout during the wire-protocol handshake. An attacker can open a TCP connection to the MOOSDB port and send no data, causing the accept thread to block indefinitely while holding the socket-list lock, preventing all subsequent client connections. |
| A security vulnerability has been detected in sgl-project SGLang up to 0.5.19. Affected by this issue is the function Session.create_req of the file python/sglang/srt/session/session_controller.py of the component Session Cleanup. Such manipulation leads to denial of service. The attack may be performed from remote. The exploit has been disclosed publicly and may be used. The pull request to fix this issue awaits acceptance. |
| A flaw was found in GLib. GVariant deserialization fails to validate that the input conforms to the expected format, leading to denial of service. |
| OpenSSH server (sshd) 9.1 introduced a double-free vulnerability during options.kex_algorithms handling. This is fixed in OpenSSH 9.2. The double free can be leveraged, by an unauthenticated remote attacker in the default configuration, to jump to any location in the sshd address space. One third-party report states "remote code execution is theoretically possible." |
| A flaw was found in the GNU C Library. A recent fix for CVE-2023-4806 introduced the potential for a memory leak, which may result in an application crash. |
| Unspecified vulnerability in Oracle Java SE 6u101, 7u85, and 8u60; Java SE Embedded 8u51; and JRockit R28.3.7 allows remote attackers to affect availability via vectors related to JAXP, a different vulnerability than CVE-2015-4893 and CVE-2015-4911. |
| Issue summary: Checking excessively long DH keys or parameters may be very slow.
Impact summary: Applications that use the functions DH_check(), DH_check_ex()
or EVP_PKEY_param_check() to check a DH key or DH parameters may experience long
delays. Where the key or parameters that are being checked have been obtained
from an untrusted source this may lead to a Denial of Service.
The function DH_check() performs various checks on DH parameters. One of those
checks confirms that the modulus ('p' parameter) is not too large. Trying to use
a very large modulus is slow and OpenSSL will not normally use a modulus which
is over 10,000 bits in length.
However the DH_check() function checks numerous aspects of the key or parameters
that have been supplied. Some of those checks use the supplied modulus value
even if it has already been found to be too large.
An application that calls DH_check() and supplies a key or parameters obtained
from an untrusted source could be vulernable to a Denial of Service attack.
The function DH_check() is itself called by a number of other OpenSSL functions.
An application calling any of those other functions may similarly be affected.
The other functions affected by this are DH_check_ex() and
EVP_PKEY_param_check().
Also vulnerable are the OpenSSL dhparam and pkeyparam command line applications
when using the '-check' option.
The OpenSSL SSL/TLS implementation is not affected by this issue.
The OpenSSL 3.0 and 3.1 FIPS providers are not affected by this issue. |
